Re: New Device Firmware Rolled Out
Tim....
If you would be so kind as to tell the some of us who may need to re-boot manually, after you've made the push, I'm sure it will be appreciated.
Re: New Device Firmware Rolled Out
Quote:
Originally Posted by
burris
Tim....
If you would be so kind as to tell the some of us who may need to re-boot manually, after you've made the push, I'm sure it will be appreciated.
For those rebooting manually, you can do it whenever you're ready.
Re: New Device Firmware Rolled Out
To be sure...
Should the firmware server path still read..
firmware.voipo.com/handytone-502
and the firmware file prefix read 1.0.1.8/
Re: New Device Firmware Rolled Out
Quote:
Originally Posted by
burris
To be sure...
Should the firmware server path still read..
firmware.voipo.com/handytone-502
and the firmware file prefix read 1.0.1.8/
Right. When you reboot, it'll bump it up to 1.0.1.21.
Re: New Device Firmware Rolled Out
Does the config server path need to be populated as well or are you going from the MAC? Mine hasn't moved up yet.
Is this the very same firmware update that appears on the Grandstream site and if it doesn't come down from your switch, would it be ok to download it from them?
Re: New Device Firmware Rolled Out
Quote:
Originally Posted by
burris
Does the config server path need to be populated as well or are you going from the MAC? Mine hasn't moved up yet.
Is this the very same firmware update that appears on the Grandstream site and if it doesn't come down from your switch, would it be ok to download it from them?
If you don't have the config server path in there, provisioning isn't enabled on your account. You could use that firmware, yes. It's the same. If you want to go the provisioning route, the best thing to do is call in for that. Either should be fine.
Re: New Device Firmware Rolled Out
I'm typically behind the router. I turned off the unit, rebooted and am still at the .8 level. I them moved the ATA in front of the router for a good 10 - 15 minutes, waited (never saw L1 L2 lights solid) and then rebooted. Still on .8
Went to Grandstream site and D/L'd firmware but cannot find where to upload via the GS Web Interface unless it is under the Advanced settings for which I'm locked out.
Re: New Device Firmware Rolled Out
Quote:
Originally Posted by
dtrose
I'm typically behind the router. I turned off the unit, rebooted and am still at the .8 level. I them moved the ATA in front of the router for a good 10 - 15 minutes, waited (never saw L1 L2 lights solid) and then rebooted. Still on .8
Went to Grandstream site and D/L'd firmware but cannot find where to upload via the GS Web Interface unless it is under the Advanced settings for which I'm locked out.
Try now. It was being set up in batches. All are ready now.
Re: New Device Firmware Rolled Out
Quote:
Originally Posted by
VOIPoTim
Right. When you reboot, it'll bump it up to 1.0.1.21.
Did it, and all is working well. It now says 1.0.1.21.