PAP2T - Uniden phone not ringing???

[bretski]

I received a PAP2T today to replace a gt502.

For some reason, my Uniden CLX485 phone will not ring when attached to this ATA. Is there something stupid that I'm missing here? Yes, the ringer is on, and it worked with the gt502. Thanks for any insight.

edit: I did some searching on the 'net after posting, and found this:

"Linksys ATAs come from the factory set to ring the widest variety of phones. Unfortunately, this is not the true US standard, so phones that strictly comply with that standard will not ring. In the middle of the Regional page, look for the "Ring and Call Waiting Tone Spec" group of parameters. To match the US standard, Ring Waveform should be Sinusoid (although Trapezoid may work better for you), Ring Frequency should be 20 (this is the most important, as 25 is the European standard), and Ring Voltage should be 90 (although something less, like 70, should work)."

These settings appear to be admin level, which I don't have access to at the moment...so I guess I'm SOL until I can speak with support.