Anyone using 2 or more lines with m0n0wall or pfSense router ?

[Bob777]

Hi chpalmer:

Thanks for the reply.

That could be the difference.

Sounds like you are using one ATA, with two VoIPo lines going to the one ATA. I have two seperate ATAs, with one phone line going to each.

So maybe I should get VoIPo to set me up with two phone numbers on just one ATA. That way I'll only have one ATA to worry with.

When you say,
"I do no port forwarding. Only built firewall rules to allow the servers access to the wan address..."
I'm not sure I understand.

Do you have a public static IP on your router wan port? I use public static IP.

What do your rules look like? Are they built into the Firewall>>>>NAT and Firewall>>>>Rules sections of pfSense?

My 2 ATAs are Broadstream model HT501. The one ATA that I can receive calls on, the "Phone 1" & "Phone 2" LEDs flash at the same time...when the phone is on the hook. But for the one ATA that I cannot receive calls on, the "Phone 1" & "Phone 2" LEDs do not flash at the same time. They alternate in flashing. One turns on, while the other is off. Then the other LED flashes on while the other LED is off. So something is definitely different (or wrong) there.

UPDATE: I got up this morning, and now the 2 LEDs are flashing simultaneously, just like the other one. That might be a good sign.