PDA

View Full Version : Call waiting not working?



altecmak
01-24-2009, 02:10 PM
When I am on the line with someone and there is someone else trying to call me...I get a beep telling me there is another call so I take it by hitting flash...when I do it beeps twice and cuts off that caller...I was wondering if my config was not correct. Btw my ATA is behind the router (I know this isnt recommended but everthing is working like it should except this little problem). Also I placed my ATA in DMZ mode on my router. Thank You.

burris
01-24-2009, 02:25 PM
When I am on the line with someone and there is someone else trying to call me...I get a beep telling me there is another call so I take it by hitting flash...when I do it beeps twice and cuts off that caller...I was wondering if my config was not correct. Btw my ATA is behind the router (I know this isnt recommended but everthing is working like it should except this little problem). Also I placed my ATA in DMZ mode on my router. Thank You.

Check to see that you have the latest firmware..1.0.1.21

If you have an earlier version, that may be your problem.

altecmak
01-24-2009, 02:51 PM
Check to see that you have the latest firmware..1.0.1.21

If you have an earlier version, that may be your problem.

I upgraded the ATA to 1.0.1.21 but the problems still persists...

burris
01-24-2009, 02:56 PM
I upgraded the ATA to 1.0.1.21 but the problems still persists...

This may sound silly, but you did reboot the ATA after the upgrade?

I had to do so..

altecmak
01-24-2009, 04:00 PM
This may sound silly, but you did reboot the ATA after the upgrade?

I had to do so..

No, but I will do it and see if that fixes it...

altecmak
01-24-2009, 05:21 PM
No, rebooting didn't work either.