PAP2T dialtone time-out

[KenH]

My provisioned PAP2T 'dialtone time-out' (busy signal after no number input) is set for 5 seconds. Is yours the same?

Also, what ports is your device using?

[bretski]

Yes. Funny you mentioned this, I just made a comment about it to support (yesterday afternoon). I had mine changed to 7 seconds, as 5 is too short for me. The ht502 is set to around 6 or 7 seconds, AFAIK.

Port range for the PAP2 is 16384 - 16482.

[KenH]

Thanks, Bretski.

My PAP2 default is 10 seconds.

What ports (as shown on vPanel) are assigned to your PAP2T?

I think I'm going to use my BYOD PAP2; there are just too many things going on with provisioning and I require some custom settings. Maybe when they get everything ironed-out, I'll try the PAP2T again.

Ken

[bretski]

vPanel shows 5060 and 5061.

[KenH]

vPanel shows 5060 and 5061.

Thanks! My provisioned device did also.

Ken