I'm remote and have no physical access to my ATA.
Went to vPanel to see if I had any voicemails and under devices
:eek:
"You do not currently have any devices registered to our servers!"
Printable View
I'm remote and have no physical access to my ATA.
Went to vPanel to see if I had any voicemails and under devices
:eek:
"You do not currently have any devices registered to our servers!"
I am registered. I would make sure the internet connection is up. My internet was down for about 30 minutes due to high wind this morning.
Is this your Grandstream or PAP2?
It's up.
2nd from the bottom.
http://www.dslreports.com/testhistor...=ec&sort=z&p=2
Some time after 2:41 EDT it re-registered on it's own.
It's the PAP2T - I left that in place. As noted above - it re-registered sometime around 2:41 EDT. It was unregistered prior to my 1st post and for some period after that > 30 minutes.Quote:
Originally Posted by VOIPoTim
I do need to open a ticket - since both Line1 and Line2 are appearing in vPanel on Port 5060 - so something's not quite right, I suspect.
Just noticed mine was also "not registered". Mine is a Grandstream.Quote:
Originally Posted by dbmaven
Have you not gotten your replacement PAP2 yet?Quote:
Originally Posted by NY Tel Guy
Nevermind, I see it's still in transit.Quote:
Originally Posted by VOIPoTim
Ok I was just going to reply to you but you beat me to it. I'll swap it and see what happens.Quote:
Originally Posted by VOIPoTim
Actually this worked to my advantage this morning. I knew I had forwarding turned off and said to myself that I'd turn it on when I get to the office.
I forgot but I still got the call I was expecting because the fail over number I had was the same as the number I was supposed to forward to, and since it was not registered, it failed over to my cell.
I just invented "dumbass forwarding"......For people too stupid to remember to forward their important calls. :-)
PAP2T arrived today. Plugged it in and it actually works better than the Grandstream which I will be sending back Saturday.Quote:
Originally Posted by VOIPoTim
Gone is the choppiness on audio and when I call into my cell voice mail, the DTMF tones work.
Interestingly, the Grandstream always showed my public IP when it was registered whereas the Pap2T shows my NAT address a-la 192.168.1.7 etc.
To test it, I unplugged my Fios router and left the power live on the pap2. When I re-established Internet connectivity, the PAp2 registered right away.
So far, so good.
FYI - the GS will re-register under that condition as well. If WAN is lost, it will re-register upon re-connection automatically. It's the lost registration without a change in WAN status where it sometimes does not re-register.Quote:
Originally Posted by NY Tel Guy
See and mine would not. I would get a new IP address or shut the router off etc. and when it came back - no registration. Bizarre.Quote:
Originally Posted by voipinit