Something stuck? No Vpanel or inbound calls

[dcshobby]

For vPanel, have you tried going to /logout and the back? It sounds like maybe there's a session caught or something that that could clear out.

Reboot the ATA and it should be up. We've seen a few more reports of registrations dropping than normal lately (maybe due to growth) so we made a few changes today which hopefully should nip that before it starts growing into a bigger issue.

Basically we've adding more NAT keep-alive components, reduced the re-registration interval and will be rolling out a few more changes over the next few days.

Overall the combination of things should help virtually eliminate this ever happening.

When you implement these new changes, could you please post them here and tell us what changes were made? Also, for those of us behind a router, do we need to reboot our ATA to get these new changes? Thanks!

[Vumes]

When you implement these new changes, could you please post them here and tell us what changes were made? Also, for those of us behind a router, do we need to reboot our ATA to get these new changes? Thanks!

I do believe that behind a router we will always have to reboot. I had the registration drop as well and just realized it when i was calling home, and it was ringing on my failsafe device (cell phone). I looked in my vPanel and noticed that nothing was registered so I remoted into my PC at home and rebooted my ATA and that was all it took.

[sr98user]

I lost registration around 3pm. Had to reboot the adapter. Doesn't it try to register every 5 or 10 minutes?

I know PAP2 checks the provisioning file every 1 hour (depending on the interval set). I hope GS502 has something similar to that.

[burris]

My line one lost registration this morning until I rebooted...then all was well.