*67 question

[bdyelton]

Just tried out *67 to my cell and the VOIPO number appeared on my cell. Is this because I am using the new Linksys pap2 ??

I just get a busy signal when I use *67...when I dial the number without *67, it goes through just fine...great...

[VOIPoDylan]

For those of you using PAP2T and experiencing trouble using the *67 code - can you please open a support ticket so we can further investigate this? We suspect that this could relate firmware - we'll need to look into it though for an official conclusion.

[burris]

I haven't hooked up my PAP2, but with my SPA-2102, I also get the busy signal immediately. Probably firmware related.

[VOIPoDylan]

I want to add here that the star codes mentioned in this thread are beta and intended for the ht502 devices only. The PAP2T codes will soon be released alongside the ht502 star codes which eventually will be rolled out to our KB and website making them 'official'.

[Smiles]

I want to add here that the star codes mentioned in this thread are beta and intended for the ht502 devices only. The PAP2T codes will soon be released alongside the ht502 star codes which eventually will be rolled out to our KB and website making them 'official'.

Thank you!