Star commands for PAP2T?

**Xponder1** · 03-21-2009 04:30 PM

Originally Posted by ralfaro

I've done my searching through the forums and the support knowledge base regarding this but have only come up with a message from Tim posted quite some time ago stating that a list would be posted soon.

Is there a list of star commands that are supported for the pap2t? I'm assuming they may be different from those for the GrandStream.

RA

I also would like to know what * commands are enabled on the PAP2 and if its possible to transfer a call.

**ralfaro** · 03-21-2009 06:21 PM

After emailing Voipo support, I did get an answer on this. Basically, I was told that the star commands for the pap2t will be the same as those for the GrandStream, but the are all still in beta. From another thread, the commands listed were:
*20 [phone_number] - Call Forward
*21 - Call Forward Disable
*22 - DND Busy
*23 - DND - Voicemail
*24 - DND Disable
*25 [phone_number] - Set Failover Number
*26 - Set Failover to Voicemail
*69 - Return Last Call
*27 - Add Last Caller to Blacklist
*67 - Block Caller ID (Single Call)
*30 - Block Caller ID (All Calls)
*31 - Unblock Caller ID (All Calls)
*82 [phone number] - Send Caller ID (Single Call)

RA

**fisamo** · 03-21-2009 07:01 PM

Originally Posted by Xponder1

I also would like to know what * commands are enabled on the PAP2 and if its possible to transfer a call.

You can always try the hookflash then hangup transfer method. (I'm running BYOD, so my test wouldn't necessarily be accurate for provisioned users.) With the first call connected, hookflash over to the "second line", dial the number you'd transfer the call to, then hang up. If transfer is supported, the other calls would be connected. Do you have two other lines you can test it with (like two cell phones)?

**Xponder1** · 03-21-2009 08:36 PM

Originally Posted by fisamo

You can always try the hookflash then hangup transfer method. (I'm running BYOD, so my test wouldn't necessarily be accurate for provisioned users.) With the first call connected, hookflash over to the "second line", dial the number you'd transfer the call to, then hang up. If transfer is supported, the other calls would be connected. Do you have two other lines you can test it with (like two cell phones)?

I have tested that and it does not work