Change outbound caller ID name?

[usa2k]

http://www.dslreports.com/forum/r223...cement-to-test

Calling cloned line to cloned line, did not show my changes.
(Even though the name field is only VOIPo to VOIPo.)

[Xponder1]

I logged in today and for some odd reason the feature "block caller id" was enabled-strict.

I do not recall seeing a strict option before and I never set that. So I think when it was added it defaulted to enabled-strict. I would recommend at least a few of you check yours.

[brhalltx]

I logged in today and for some odd reason the feature "block caller id" was enabled-strict.

I do not recall seeing a strict option before and I never set that. So I think when it was added it defaulted to enabled-strict. I would recommend at least a few of you check yours.

I noticed that too, and turned it off as a guess. That could have been my problem with calls to Vonage not going through...

[Xponder1]

I noticed that too, and turned it off as a guess. That could have been my problem with calls to Vonage not going through...

I submitted a ticket. If we both had the issue then support needs to be aware of it.

EDIT- Noticed audio gain defaulted to low too. Support is looking in to it.

[Russell]

What's the difference between "Enabled" and "Enabled - strict"?

[Xponder1]

What's the difference between "Enabled" and "Enabled - strict"?

I wondered the same thing.

[usa2k]

I just turned mine off too.