Alternate Device Testing

**drearick@lavabit.com** · 07-06-2009 12:16 PM

Tim, count me in for testing a RT31P2;

RT31P2- yes, it's the same model as Vonage uses/used; I'm on my original one from 03/2005; been rock solid for me (knock on wood)

**Russell** · 07-09-2009 08:03 PM

Originally Posted by VOIPoTim

We should be contacting some of you in a week or so about this.

Just wondering if the lucky ones have been contacted :-).

**VOIPoTim** · 07-09-2009 08:20 PM

Not yet.

Took a little longer than expected to prep them.

We plan to contact people by the end of next week.

**Hawkmeister** · 07-10-2009 07:16 AM

Tim,

If you need another to test, add me to the list. I may need some help from you staff configuring my other Linksys router behind it.

**darylo** · 07-10-2009 02:49 PM

I'll test too if needed.

**mboudoin** · 07-11-2009 07:39 AM

Same with me. Add me to the list if you still need someone.

**burris** · 07-17-2009 12:28 PM

Originally Posted by VOIPoTim

Not yet.

Took a little longer than expected to prep them.

We plan to contact people by the end of next week.

Got the RT31P2 today...Waiting for instructions to proceed..

**VOIPoTim** · 07-17-2009 12:34 PM

Originally Posted by burris

Got the RT31P2 today...Waiting for instructions to proceed..

That was quick.

We'll e-mail out a list either today or Monday of things we'd like to have everyone test.

It should be plug and play right now though for normal use.

**burris** · 07-17-2009 01:01 PM

A few quick test results...

Since I have a router, I hooked it up just like the PAP2....

Both lines dial out OK.

Cannot call one cloned line to the other. Goes to failover.

The first inbound try rang only to line 1...since that call....
When calling in from cell...rings once and voice quickly answers "no messages" and disconnects.

Since I can't get into the config, I don't know how it is set up or what might be causing these issues..

I have to take it off line now since I get no incoming.

Might be handy to assign a temp DID so we can leave it on all the time and test over a period of time..

**VOIPoTim** · 07-17-2009 01:16 PM

Originally Posted by burris

A few quick test results...

Since I have a router, I hooked it up just like the PAP2....

Both lines dial out OK.

Cannot call one cloned line to the other. Goes to failover.

The first inbound try rang only to line 1...since that call....
When calling in from cell...rings once and voice quickly answers "no messages" and disconnects.

Since I can't get into the config, I don't know how it is set up or what might be causing these issues..

I have to take it off line now since I get no incoming.

Might be handy to assign a temp DID so we can leave it on all the time and test over a period of time..

Ok, just hang tight and by Monday we'll post a new thread with the formal testing info and how we're handling things.