Alternate Device Testing

[chpalmer]

I have problems trying to register in parallel, even with the two adapters on separate public IP addresses...

And Brandon confirmed these problems would happen.

[Russell]

I asked Tim about this early on, but don't remember if there was an answer.

I'm not they will both register if in parallel.

Yes, I know and ran it in this mode for a while but had some issues at which point I pulled the plug. The purpose of the question was to determine if both adapters simultaneously on was considered a scenario that was expected to work and if Xponder was doing so.

[burris]

I also suggested awhile back that maybe they could assign a temp DID for the testers...that way we could leave it hooked up and any testing wouldn't interfere with our main line.
I don't remember if I heard back..

[Xponder1]

I'm sure you've mentioned it somewhere in this thread ... but things change. Are you using the test devlce as a replacement for the original or are you running both in parallel?

I disconnected my PAP2 and I am using this instead. I did however "try" to make it work with both but it was a epic fail. Once you get it up and running you should not need the PAP2. It works fine.

[VOIPoBrandon]

Just an update for you guys --- you now should be able to use both the RT31P2 device and PAP2T / etc in parallel. We've made a change that will now allow this.

Happy Testing!
________
Glass Pipes

[Xponder1]

Just an update for you guys --- you now should be able to use both the RT31P2 device and PAP2T / etc in parallel. We've made a change that will now allow this.

Happy Testing!

Well I am happy with device as is but this will make some of the others more likely to use theirs. Sounds good.

[chpalmer]

Just re-enabled that line on my pap2 so both devices now active and seems to be working correctly...

[burris]

Just re-enabled that line on my pap2 so both devices now active and seems to be working correctly...

If you hook up both ATAs and they are both provisioned to your main number along with the clone feature, what is the process?

[Russell]

If you hook up both ATAs and they are both provisioned to your main number along with the clone feature, what is the process?

Things are getting pretty hairy, I'd say!

[VOIPoTim]

If you hook up both ATAs and they are both provisioned to your main number along with the clone feature, what is the process?

It should be fine actually. All should ring.