Quote Originally Posted by VOIPoTim View Post
In terms of * codes, that sounds like a DTMF setting where it's being recognized on one and not the other...just e-mail and ask support what you should have your DTMF set to...I'm honestly not sure which method we use...too technical for me.

In terms of other settings, I'm not sure what you're really needing. Your device may have lots of settings, but the ones ones that are rally needed are the SIP info, codec info, and DTMF info. There's nothing else really to provide since the rest are just built into the device and up to you whether you choose to use them or not. We can't get into all the special settings each device has since they have nothing to do with us or our service.

Just contact reseller support about the DTMF tone question and also if you have any specific questions about the basic settings and we'll be happy to help.
Tim

Its not DTMF, on sip.voipwelcome.com when doing say *20+(Phone number) or *21 i get a busy signal response, but the code still goes through and forward/un-forward the number. Now with the same configuration, ONLY change is to sip7.voipwelcome.com I get the "Thank You" response to the *20+(Phone number) or *21.

So something is different with the sip.voipwelcome.com & sip7.voipwelcome.com servers. Also this does the same with Voipo ATA you guys sent me years ago.

Also i found out with sip7.voipwelcome.com i have to set DTMF to "In audio" and on sip.voipwelcome.com i have to set DTMF to "RFC2833" for digits to be recognized on the Voice Mail System (123).

So something is different between the two sip's.