freePBX Asterisk problem

**john** · 05-14-2008 08:43 AM

FWIW, I made all the suggested changes and still get the same error: WARNING[2350] chan_sip.c: Forbidden - wrong password on authentication for INVITE to '"305777xxxx". Security sure has been tightened! If I can't figure it out I will create a ticket.

BTW: I like what the Gizmo5 is doing. For $4/yr they let you set your Outgoing Caller ID. Setting the Caller ID to the home phone number is a must for the wife factor.

**dswartz** · 05-14-2008 08:56 AM

John, one gotcha you may have missed: the outbound context MUST now be called voipo.com. I had been using VOIPO for outbound and VOIPO_in for inbound and even with all the other changes, still no joy. I noticed Ray had the outbound context as voipo.com and changed to that and was good to go.

**dswartz** · 05-14-2008 09:09 PM

Well, this sucks. Just tried making a call, and it went through, but then I got an email from the script that alerts me when a trunk is down. Checked, and sure enough, no voipo. I have NOT changed anything...

Looking at 'sip show peers', codeblue is showing as unreachable, so maybe something's going on. I'll check again tomorrow.

Update this AM: still down. codeblue.voipo.com is still showing as UNREACHABLE. At least inbound still works

**john** · 05-15-2008 07:44 AM

Shows UNREACHABLE for me also this morning.

VOIPoNorm · 05-15-2008 08:00 AM

John,

Can you please open a ticket at http://support.voipo.com

Please include the sip.conf context you are using to connect.

Also, please include the SIP phone number you're using to connect.

Regards,
Norm

**dswartz** · 05-15-2008 08:31 AM

Norm, I opened a ticket too. The sip info is exactly the working one I PM'ed you...

**fisamo** · 05-15-2008 10:05 AM

I was just able to place a few outbound calls (via DISA) on my Residential line. I used the outbound trunk settings posted earlier in the thread, copied below:

host=codeblue.voipo.com
username=919249xxxx
secret=(secret, of course)
type=friend
insecure=invite
qualify=yes
nat=yes
port=5060
fromuser=919249xxxx
fromdomain=919249xxxx
context=voipo

I have not played with other settings (that I recall) to significantly change them from the default PBX-in-a-Flash setup. (I recently backed up my Trixbox, then over-wrote with PIAF to see if I like PIAF better.) However, I'll see if I can sanitize and retrieve my entire config files so I can post them.